ATD Tools ATD-10528 Instruction Manual download pdf (Page 8)

ASSEMBLY

WARNING:

Always remove battery pack from your saw when you are assembling parts, making adjustments,

assembling or removing blades, cleaning, or when not in use. Removing battery pack will prevent

accidental starting that could cause serious personal injury.

Inserting/Removing Battery Pack

TO INSERT:

1. To insert the battery pack by sliding battery pack into the body of the tool. Insert the battery pack until

the battery latches lock.

TO REMOVE:

1. To remove the battery pack, press in both battery latches and slide the battery pack off of the tool.

2. Make sure the latches on each side of the battery pack slip into place and battery pack is

secured to saw before beginning operation.

TO INSTALL SAW BLADE (Fig. 4)

1. Remove battery pack first.

WARNING:

Failure to remove battery pack from saw could

result in accidental starting causing possible

serious personal injury.

2. Loosen the blade clamp screw enough to

permit the saw blade to be inserted between

blade clamp and saw bar, by the blade wrench.

Note: it is never necessary to remove the blade

clamp screw from the blade clamp when

installing or removing blade.

3. Align the hole in the shank of the blade and blade clamp with the pin in the saw bar, and then seat both

on the pin in the saw bar.

Note: The wrench hole is used for wrench to

install the blade.

4. Tighten blade clamp screw securely.

5. Remove blade wrench and store it.

6. Replace battery pack.

Note: there may be times when the blade clamp

sticks to the saw bar and will not loosen enough

to allow blades to be installed or removed. If this

happens, loosen the blade clamp screw with the

blade wrench, then tap lightly on the end of the

blade wrench with a mallet. (Fig. 5)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

ATD Tools ATD-10528 Instruction Manual Page 8